User Tools

Site Tools


documentation:cnc_routers:shapeoko2

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
documentation:cnc_routers:shapeoko2 [2019/11/22 22:55]
shchang [Dewalt Collets]
documentation:cnc_routers:shapeoko2 [2019/12/05 01:18] (current)
shchang [Training]
Line 7: Line 7:
 You must be signed off to use the Shapeoko 2. There are 2 ways to get signed off: You must be signed off to use the Shapeoko 2. There are 2 ways to get signed off:
   - **Class option:** Take a Shapeoko 2 introductory class (occasionally offered through Eventbrite).   - **Class option:** Take a Shapeoko 2 introductory class (occasionally offered through Eventbrite).
-  - **Self-guided option:** Read this wiki page. Email cnc@tcmaker.org for permission to operate the Shapeoko for the purpose of learning. Then you will be permitted to setup, home, jog, and zero the machine. You may create ​your CAD/CAM design, but don't run your GCode yet. Just practice setting up. Once you are ready to rout your first design, schedule a time with the CNC manager ​or other qualified person for demonstrating competency. You should be able to+  - **Self-guided option:** Read this wiki page. Once you have created ​your CAM design/GCode file, schedule a time with the CNC manager ​to demonstrating competency. You should be able to
   * Turn on and off the machine   * Turn on and off the machine
   * Home the machine   * Home the machine
Line 14: Line 14:
   * Change router bits   * Change router bits
   * Set the zero position   * Set the zero position
-You will finally run your CAM program ​(it must be your own design)+During checkoff, you will perform ​your cut (it must be your own design)
  
 +If you need time in front of the machine to practice, email cnc@tcmaker.org for permission to operate the Shapeoko for the purpose of learning. Then you will be permitted to setup, home, jog, and zero the machine. You may create your CAD/CAM design, but don't run your GCode or turn on the spindle until you are ready to get signed off.
 =====Safety===== =====Safety=====
 ---- ----
documentation/cnc_routers/shapeoko2.1574463307.txt.gz · Last modified: 2019/11/22 22:55 by shchang